Challenge Accepte..ugh.

DesignMakeTeach issued the challenge and I rose to answer it... sort of.

To be fair, I already knew I was going to have problems with the overhangs. Overhang issue aside this, I think, is the best way to print this object. All overhangs become gradual slopes with few exceptions, and the majority doesn't even need the supports. You don't need to cut the model in half and glue anything together. Just a little supports and your done. And some PLA. Use PLA when using supports.

Am I going to plug my book with every post I do from now on? You bet I will.