Support my habit, Get cool Stuff

Sunday, May 6, 2012

Suddenly success!

After watching a Replicator G tips and tricks video I figured out how to raise the platform temperature and had my first successful print. A mini shark clip with an 8mm hex wrench on the back. Unfortunately I scaled down the shark and it may be too small to use to hold my pants away from my bike chain. But at least I have the wrench for that pesky bolt.

But now I have another problem.
The picture isn't entirely clear but the first few layers after the raft didn't stick right. It's really messy on that side. Not sure what to do about that....

EDIT: The clip part of the shark works fine for holding my pants as desired, but the wrench part is only 4mm and not deep enough. Oh well, at least I can use it partially for what it was intended.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.