Support my habit, Get cool Stuff

Friday, May 18, 2012

Nuthin's printing

I intended this blog to be a frank and open discussion about owning a 3D printer. Well, after 2 week the darn thing isn't printing anything. Maybe it's because it was generally too cold. maybe it's because the extruders are gunked up. Tomorrow I'm going to call around and see if I can get some acetate, clean the extruders, run it through some maintenance, and see if I can finally print a chess set.

But tonight was frustrating.

No comments:

Post a Comment

Note: Only a member of this blog may post a comment.