Friday, November 9, 2012

Ditto printing on Sailfish

So good news. Sailfish has an option under General Options called "Ditto" that when you turn it on runs both extruders at once. So no more running gcode through an exe to do that. The bad news, tho, is if you forget to turn it off...
Don't forget to turn it off when you're done with it.

Congrat to Dan and Jetty for making that a reality, tho.
at

3 comments:

  1. UnknownNovember 9, 2012 at 3:33 PM

    Looks like you have a nice Christmas tree ornament though. :)

    ReplyDelete
  2. 3dpprofessorNovember 9, 2012 at 4:20 PM

    Super ironic that this is what I was printing: http://www.thingiverse.com/thing:27388

    Hmm, a christmas tree decorated with printing scraps. Somehow don't think the missus will go for it.

    ReplyDelete
  3. MrCharlieNovember 10, 2012 at 3:11 AM

    haha, it does make for a nice effect (hopefully it doesn't jam up your extruders when that happens)

    Also: Raspberry Pi. Mmmmmm

    ReplyDelete

Note: Only a member of this blog may post a comment.