tag:blogger.com,1999:blog-1044435882628584601.post4663024062812653577..comments2023-09-25T04:07:32.693-06:00Comments on Joe's Makerbot: 3D Printing Tip - Painting your prints3dpprofessorhttp://www.blogger.com/profile/09302309534971264219noreply@blogger.comBlogger3125tag:blogger.com,1999:blog-1044435882628584601.post-60258125208255629992016-12-23T21:37:55.441-07:002016-12-23T21:37:55.441-07:00This comment has been removed by a blog administrator.Anonymoushttps://www.blogger.com/profile/17761973156880318332noreply@blogger.comtag:blogger.com,1999:blog-1044435882628584601.post-67278086563024140282012-10-21T21:49:44.355-06:002012-10-21T21:49:44.355-06:00Update on this one. I put a Guy Fawkes mask painte...Update on this one. I put a Guy Fawkes mask painted in blue in my pocket to see how much wear it can handle. And I forgot about it, it went through the wash, and came out... completely unharmed. Nail polish. The best paint for ABS. Who knew?3dpprofessorhttps://www.blogger.com/profile/09302309534971264219noreply@blogger.comtag:blogger.com,1999:blog-1044435882628584601.post-20822181877804341832012-10-08T19:25:22.383-06:002012-10-08T19:25:22.383-06:00I've found it's a decent alternative to mo...I've found it's a decent alternative to more expensive paints. The trick to making it last longer is to spray on some lacquer to seal it completely. Can get it in matte or glossy and a huge $6 can will probably go a long way with the small forms you're printing.Anonymoushttps://www.blogger.com/profile/03347487126727827822noreply@blogger.com